The default com settings are 115200,N,8,1, I know that it's so basic, but make sure your com settings match the homeworks port. A generic driver can be assigned, but it is not necessary. If, however, a specific driver has been assigned to that port in the Lutron software, that could cause problems. Typically, we only use 'Keypad Button Press' to call up lighting scenes already programmed in Homeworks and we use LED feed back for 'active/inactive' feedback. Feedback will be dependant on what monitoring functions are enabled for the serial port of the Lutron processor. The correct string sent to the serial port will cause the desired action to happen. No special driver is necessary to talk to and receive feedback from Homeworks. The code has expanded to accomodate new features, however, with Interactive, and now Illumination. Lutron serial commands have never changed from the oldest homeworks panels, (yes, the blue panels, if you've ever seen them). If you check the cable database it will show you the correct There is a jumper required for some of the control If you've done everything else and it still doesn't work, you mightwant to check the wiring of the rs-232 cable between the crestron and

Laptop and make these changes myself using Vantage's Protocol test I had to connect directly to the Lutron processor via 232 with my And lastly, he didn't turn the handshaking on. Then, the BAUD rate was left at the default of 115200 instead ofĩ600. We just finished a job controlling shades with Lutron and had someįirst, he didn't log into the 232 port, so no control till he did Sheet from Lutron's site as well as talked to tech support and doneĮverything there. I've tried using exactly what is on the 232 tech Or if not a module, a trick to getting serial You having? Define 'done everything there'.ĭoes anyone have a module for using Lutron's newer Homeworks You may need to enable feedback for the port. The only issue is with the wireless links, but thereare a The 'old' HWI modules work with the newer P5 processors (that require The lighting tech has supposedly done so since, but things Processor may need to be uploaded again with the correct RS-232ĭriver.

Lutron's last response was that the program on the Lutron The old modules use a different syntax that refers to panels and bothĬrestron and Lutron told me that they will not work with the newer Syntax given to me by Lutron as well as some variations they gave me. Into the processor and sent it codes through viewport with the exact This is an H4P5 Processor and by done everything, I've gone direct

Lutron homeworks interactive software